2020. 2. 17. 23:50ㆍ카테고리 없음
On the, I explained what the Demo/Kiosk PS3 unit was and why I got one.Today I will explain on how I spent a Saturday evening (only crawling into bed at 04h00 the next morning) converting it to a retail unit.I tried about 3 other methods and this was the one that worked for me, so YMMV. Usual disclaimers apply and if you decide to follow this guide it is at your own risk.
#1 DrLeePHD @ 2012-1-24 23:59Thank you so much!! I just ran through this tutorial with my kiosk system and it worked great!one small revision I’d reccommend though,in the 07min to 08m45 section,”When the console finishes doing its thing, ((( REMOVE THE USB STICK ))), power it back on and it will be in red box (service) mode.”It might seem obvious to most users but I managed to flash my ps3 twice since I didn’t pull the USB drive after waiting to flash the first time.Great write-up! Very well done.
E3 Card Reader Service Mode Filestream Online
Speed Queen Fault CodesBySpeed Queen Dryer Fault CodesAlrm - Break In Alarm Door - Service door or coin vault switches.E:00 - General Error - Re-aim micro-wand and try again.E:01 - Proximity Error - Micro-wand is incorrectly aimed at infrared communicator. Re-aim micro-wand and try again.E:02 - IR Communication Disconnection - Micro-wand has been removed before communication complete. Re-aim micro-wand and try again.E:05 - Invalid Value Communication - This error occurs when an invalid codes has been downloaded from the micro-wand to the electronic control. Re-aim micro-wand and try again.E:07 - Inoperative Control - Replace control board.E:08 - Inoperative Control - Replace control board.E:09 - Proximity Error - Micro-wand has been removed before communication complete. Re-aim micro-wand and try again.E:0B - IR Communication Disconnection - Micro-wand has been removed before communication complete. Re-aim micro-wand and try again.E:0C -IR Communication Disconnection - Micro-wand has been removed before communication complete.
Re-aim micro-wand and try again.E:0F - IR Communication Programmed Off - Reprogram Infrared communicator on and manually enable IR on control. Re-aim micro-wand and try again.E:OP - Open Temperature Sensor Error - Replace temperature sensor.E:SH - Shorted Temperature Sensor Error - Replace temperature sensor.EC:00 - General Communication Error - Communication problem. Try card again.EC:02 - Time Out Error - Communication problem.
Try card again.EC:03 - Invalid Command Code - Wrong machine type. Before downloading, ensure data is current for machine type.EC:05 - Invalid or Out-Of-Range Data - Wrong machine type. Before downloading, ensure data is current for machine type.EC:06 - Invalid Data Code - Wrong machine type. Card my need to be replaced.fore downloading, ensure data is current for machine type.EC:09 - Corrupted Data Error - Communication problem. Try card again.EC:0A - Invalid Machine Type - Wrong machine type.
Reader Service My Account
Before downloading, ensure data is current for machine type.EC:19 - No Card Reader Communication - Power down unit and power back up to try again. If error persists, reader or control board is faulty.EC:20 - Unreadable Card - Clean chip card and card reader contacts. If error persists, card may be bad.EC:21 - Security ID Mismatch - Wrong card. Use card with correct security code.EC:22 - Site Code Mismatch - Wrong card. Use card with correct security code.EC:23 - Card Maximum Value Exceeded - Use card which does not exceed maximum value.EC:24 - Insufficient Memory On Card - Download card contents to PC and clear card for re-use.EC:25 - Card Reader Malfunction - Card reader may need to be replaced.EC:26 - Card Write Error - Try card again.